The Lemora Seat and Hardware Kit
Hardware Kit contains plastic anchors, post on adjustable discs, screws, and disc trim caps. There are two of each.
Insert Anchors into Seat Holes Then Secure Adjustable Disc Using the Screw.
Snap On the Trim Caps
Install trims caps over the posts and push down onto the adjustable discs.
Mount Seat Onto Posts
Line up the holes located in the hinge of the seat, and then push the seat down onto the posts.
Check For Alignment
Check that seat front aligns with bowl front, and if too much overhang, then remove seat by pushing the seat release button. Remove trim caps and adjust the posts.
Comments
0 comments